
WA_DEV_FEX20_UGD_002 Rev 004 March 08, 2011 44
Fastrack Xtend User Guide
Table 16. Equivalent Circuits of CMIC2
Table 17. Electrical Characteristics of CMIC2
Internal biasing
DC Characteristics
AC Characteristics
200 Hz<F<4 kHz
Impedance between
MIC2P and MIC2N
Working voltage
( MIC2P-MIC2N)
Maximum rating voltage
(MIC2P or MIC2N)
* The input voltage depends of the input micro gain set by AT command. Refer to document [7] Firmware 7.4a
AT Commands Manual (Sierra Wireless Software Suite 2.31)/Firmware 7.4 AT Commands Manual (Sierra Wireless
Software Suite 2.30).
** Because MIC2P is internally biased, it is necessary to use a coupling capacitor to connect an audio signal
provided by an active generator. Only a passive microphone can be directly connected to the MIC2P and MIC2N inputs.
Refer to the following table for the list of recommended microphone characteristics.
Table 18. Recommended Microphone Characteristics
Compatible with GSM specifications
Comentarios a estos manuales