Sierra Wireless IP Manager Guía de usuario descargar pdf (Pagina 25)

Installing and Activating AirLink GX400

Rev 1.0 Jun.11 25

Activating the AirLink GX400

To activate your GX400:

1. Connect the needed antennas to the AirLink GX400 - See Connecting the

Antennas on page 26.

2. Remove the GX400’s decorative cover by removing the four retaining screws

with a 5/64” or 2 mm Allen wrench. Insert a SIM card into the tray. Replace

the screws and cover.

3. Plug the power cable to the power connector on the back panel of the AirLink

GX400 - See Connecting to Power on page 27.

4. Connect your computer to the AirLink GX400 with an Ethernet, serial, or USB

cable - See Connecting to a Computer or Other Device on page 28.

5. Observe the LEDs - See LED Operation on page 30.

Wait 60-90 seconds for the AirLink GX400 to initialize and go on the air.

Updating AirLink GX400 Firmware

For installing the latest firmware version (.exe file), go to the Sierra Wireless

website: http://www.sierrawireless.com/support.

Confirming the IP Address

Check the IP Address in your Local Area Connection window. The IP Address in

the window in Figure 3-2 is for a USB/net connection.

Figure 3-2: Confirm IP Address

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 46 47

Sin comentarios

Sierra Wireless IP Manager Guía de usuario Pagina 25