Sierra Wireless AceView Manual de usuario descargar pdf (Pagina 4)

AirLink Communications January 2007 4

PPPoE: Point to Point Protocol over Ethernet for AirLink Modems

a. Change *HOSTAUTH to 2.

b. Enter a username for *HOSTUID for the PPPoE connection.

c. Enter a password for *HOSTPW for the PPPoE to connection.

d. Set *DHCPSERVER to 2 (Enabled if no other DHCP server is detected).

PPPoE connections can use a Service Name to differentiate PPPoE devices. You can use Wireless

Ace to give your

modem a name.

a. In Wireless Ace, select Dynamic IP from the groups on the left.

b. Enter a name for *MODEMNAME, such as the modem model or the ESN.

FIGURE 5. Wireless Ace: *MODENMNAME

a. Click the Write button on the tool bar of Wireless Ace and wait for the message “Write Suc-

cessful” to appear in the status bar.

FIGURE 6. Wireless Ace: Write

Configure *HOSTAUTH, *HOSTUID, *HOSTPW, and *DHCPSERVER.

If you leave *HOSTUID and *HOSTPW blank, any computer or device can con-

nect to the modem using PPPoE.

Optional

Configure *MODEMNAME.

The name you choose will not affect the connection but may need to be configured

in PPPoE settings for the router, device or computer you will be connecting to your

modem.

Write the configured settings to your modem.

b. Press the modem Reset button on the front of the modem. Wait until the modem indicator is

lit and the modem has once again registered on the network.

AirLink Modem

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Sierra Wireless AceView Manual de usuario Pagina 4