
ALEOS User Guide
94 20080616
Server 2 to Server 4
There are additional servers where GPS data can be sent simultaneous to server
1.
Use Device ID in
Location Reports
Whether or not the AirLink Device should include the 64-bit device ID in its GPS reports.
*PPDEVID MUST be 1 if the device uses a Dynamic IP.
n=0 : Disable ID.
n=1 : Enable/display ID.
SNF Reliable Mode Store and Forward Reliability: GPS reports will be retransmitted if not acknowledged by the
server.
• n=0 : Disabled
• n=1 : Reliable mode enabled for RAP messages
• n=2 : Simple reliable mode
SNF Mode Store and Forward Behavior. When *PPSNF=1, the type of Store and Forward behavior is
defined by:
• n=0 : Normal Store and Forward. Data is stored when the AirLink Device is out of
cellular coverage; when the AirLink Device is in coverage, data is sent to server as
soon as possible. This is the default form AirLink Device devices with RAP version 1.3
or lower.
• n=1 : Data sent only when polled. Data is stored until polled using the Poll command
sent by a server.
• n=2 : Grouped Reports. Data is stored until the desired minimum number of reports
(see *PPSNFM) has been stored. The data is then sent to the server in groups with at
least the specified number of reports.
SNF Minimum
Reports
Store and Forward Minimum Reports. Specifies the minimum number of reports that must
be stored before they are forwarded to the server. The data is then sent to the server in
packets that contain at least this number of reports.
• n=0-255
SNF Simple Reliable
Max. Retries
Maximum number retries when in Simple Reliable Mode.
• n=0 : Disabled
• n=1-255 retries
Table 9-1: GPS: Server 1
Command Description
Comentarios a estos manuales