Sierra Wireless AirLink MP Guía de usuario descargar pdf (Pagina 36)

ALEOS User Guide

30 20080616

Serial

Note: The Serial tab that

displays in ACEmanager,

is applicable to all Sierra

Wireless AirLink devices

except Raven XE.

Figure 3-8: ACEmanager: Status - Serial

Command Description

Serial Port Mode Default power-up mode for the serial port: When the AirLink device is power-cycled, the

serial port enters the mode specified by this command after 5 seconds. On startup, typing

ATMD0 within 5 seconds changes the mode to normal (AT command) mode.

TCP Auto Answer This register determines how the AirLink device responds to an incoming TCP connection

request. The AirLink device remains in AT Command mode until a connection request is

received. DTR must be asserted (S211=1 or &D0) and the device must be set for a

successful TCP connection. The AirLink device will send a “RING” string to the host. A

“CONNECT” sent to the host indicates acknowledgement of the connection request and the

TCP session is established.

• Off (Default)

• On

• Use Telnet server mode on TCP connections

With a Telnet connection, overrides the client's default echo, allowing the server on the host

port to perform the echo. CRLF sequences from the telnet client will also be edited to

simply pass CRs to the server on the host port.

UDP Auto Answer Enables UDP auto answer (half-open) mode.

Normal mode

Enable UDP auto answer mode.

Serial IP Packets Sent Number of bytes sent over serial port to host.

Serial IP Packets

Received

Number of bytes received over serial port from host.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 236 237

Sin comentarios

Sierra Wireless AirLink MP Guía de usuario Pagina 36