Sierra Wireless AirLink MP Guía de usuario descargar pdf (Pagina 24)

ALEOS User Guide

18 20080616

Note: AT commands work for the port on which they are executed. For example, if the

user types ATE1 and then AT&W using a USB/serial port connection, it will set the USB/

serial port to Echo On but not the telnet connection or the RS232 serial port.

PassThru Mode

In PassThru mode, the AirLink device does not behave normally, all port

communication is passed directly between the internal hardware and the

computer connected directly to the device. This mode can be used to configure

hardware-specific settings. For example, provisioning, troubleshooting,

communicating with legacy equipment, etc.

Caution:

ALEOS is disabled in PassThru Mode. You cannot use most ALEOS specific

commands while the device is in PassThru Mode. While in PassThru mode, you also

cannot use ACEmanager or the USB port.

Telnet Mode

In ACEmanager you can configure Telnet operation.

If you need to change the port for Telnet (for example, you have the default port

blocked on your firewall), the option is on the Services-Telnet tab. The default

telnet port is 2332. You can also change the Telnet timeout, if the connection is

idle, default 2 minutes. This is the internal telnet on the modem to pass AT

commands and not TCP pad.

Figure 2-2: ACEmanager : Services- Telnet

Applying Templates

If you have a device configuration that works well for your needs, using

ACEmanager, you can save that device’s configuration as a template and then

apply it to other Sierra Wireless AirLink devices.

1. Creating the Template with ACEmanager

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 236 237

Sin comentarios

Sierra Wireless AirLink MP Guía de usuario Pagina 24