Sierra Wireless AirLink MP Guía de usuario descargar pdf (Pagina 131)

Rev 2.0 C Aug.10 125

15: Events Reporting Configuration

• Digital Inputs

• Analog Inputs

• Other

• Network

• Configuring Reports

• Reports

• Groups

• Configuring Data

The Events Reporting tab that displays in ACEmanager, is applicable

across all Sierra Wireless AirLink devices.

Events Reporting allows the users to generate reports from the

events that take place. Event Reporting Protocol is an intuitive

embedded protocol, which automatically formats the messages

based on an event trigger. The messages generated are then

reported to the remote server.

An event occurs, when any of the following takes place:

• Customer device opens or closes a switch

• Customer device raises or lowers analog voltage

• device RSSI goes below or above a threshold

• device power goes below or above a threshold.

A report is generated when the device sends a message caused by

an event.

Both events and reports are configured by the customer and can be

considered as the “next Generation” of RAP.

The Events groups define the triggers for reports.

Event Trigger

There are 16 data types that can trigger events. The configuration for

the trigger will vary based on the data type. An “event” is when the

data in the configured state. Some examples are: a switch is closed,

the speed is greater than 70 MPH, the engine has been used for

1000 hours and needs maintenance.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 236 237

Sin comentarios

Sierra Wireless AirLink MP Guía de usuario Pagina 131