Sierra Wireless AirLink MP Guía de usuario Pagina 40

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 237
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 39
ALEOS User Guide
34 20080616
Carrier
type
Command Description
EV-DO/1X Dormancy
Idle Timer
(secs)
Inactivity timer, in seconds. Typical network settings cause a link to go dormant after 10
to 20 seconds of inactivity, no packets transmitted or received. This time can be
shortened to release the physical RF link sooner when the application only transmits
short bursts.
n=0 : Allows the cellular network to determine the inactivity timer.
n= seconds (maximum 20 seconds)
EV-DO/1X Mobile IP Mobile IP (MIP) Preferences. On a Mobile IP network, a device connects to the network
using PPP. During the negotiation process the AirLink device is NOT required to present
a username and password to authenticate because the authentication parameters are
stored in the device itself.
n=0 : Disabled, SIP only
n=1 : MIP preferred
n=2 : MIP only
Note: Your account with your cellular carrier may not support Mobile IP.
EV-DO/1X MSL Code The NAMLCK is the device's 6-digit OTSL (One Time Subsidy Lock), MSL (Master
Subsidy Lock), or SPC (Service Provisioning Code). Your cellular carrier will provide the
unlock code.
nnnnnn=6 digit unlock code
Note: If the number is accepted by the device, the OK result code is returned. If the
number is rejected, the ERROR result is returned. If three successive Errors are
returned, the device must be reset by Sierra Wireless AirLink Solutions to allow any
further attempts. The device permits 99 failures of this command during its lifetime. After
that, the device becomes permanently disabled.
EV-DO EV-DO
Diversity
EV-DO Diversity allows two antennas to provide more consistent connection.
Disabled
Allow
If you are not using a diversity antenna, *EVDODIVERSITY should be disabled.
EV-DO EV-DO Data
Service
Change the allowable Network type.
EV-DO preferred but can “fall back” on CDMA/1x
EV-DO only, fall back disabled
CDMA/1x only, EV-DO disabled
*PROVISION=MSL,MDN/MIN[,SID][,NID]
It is recommended to use the Setup Wizard for your carrier to provision the device.
Provision the device with the lock code and phone number. Cannot be configured in
ACEmanager.
MSL=master lockcode
MDN/MIN=phone number
SID=system ID
NID=network ID
Vista de pagina 39
1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 236 237

Comentarios a estos manuales

Sin comentarios