
GPS Configuration
Rev 2.0 C Aug.10 99
Local/Streaming
Figure 9-4: ACEmanager: GPS - Local streaming
*PPREPORTINPUTSR
eport inputs on RAP
Enable input reporting.
• n=0 : Disabled
• n=1 : Enabled
Note: If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are enabled, the AirLink
Device digital inputs will be reported and the COM1000 inputs will be ignored.
GPS Datum Mode Specifies the GPS datum to use for position reports. For accurate results, this value should
match the datum used by receiving mapping application.
• n=0 : WGS84
• n=92 : NAD27
• n=115 : NAD83
*PPTCPPOLLTCP
GPS Port
Specifies the port to listen on for TCP GPS report polling. The request to this port needs to
come from the same IP address in *PPIP.
• n=0 : Disabled
• n=1-65535 (default 9494)
Add GPS Time and
Lat/Long
Set or query GPS stamping of UDP Reliable packets. When set, data received on the host
serial port will be encapsulated with the GPS date and time.
• n=0 : Disabled (default)
• n=1 : Enabled
Extra inputs for
COM1000
Enables support for extra inputs from a COM1000.
• n=0 : Disable
• n=1 : Enable
Tip:
If both AT*PPCOM1000=1 and AT*PPREPORTINPUTS=1 are enabled, the AirLink
Device device’s digital inputs will be reported and the COM1000 inputs will be ignored.
Table 9-2: GPS: Misc
Command Description
Comentarios a estos manuales