Sierra Wireless AirLink MP Guía de usuario Pagina 123

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 237
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 122
Report Configuration
Rev 2.0 C Aug.10 117
Redundant Server
When a redundant server is enabled, each time a message is sent out to the
main, or failover, a second identical message will be sent to the redundant server.
This can allow the data to be used by two or more different applications.
The redundant servers can be running the same or different application than the
primary and failover servers. The messages to the redundant server are
independent of the primary/failover server settings or state.
You can set one or both redundant servers. The messages are sent
independently to either or both.
Note: Messages will be sent regardless if the server is available or not and do not use any
reliable mode format. Receipt of a message is not acknowledged nor is any message
resent. Currently, redundant servers cannot use TCP.
Store and Forward
Store and Forward will store reports when the primary Reports Server is
unavailable and forwards them when the server is available again. Store and
Forward can also groupmultiple reports in to a single message, rather than
individually.
The Report Server could be unavailable because the AirLink device leaves
coverage, has very low signal (an RSSI of -105 or lower), or the server is
unreachable, regardless will store reports in memory. When the AirLink device is
able to reach the server again, it will forward the reports.
The AirLink device can also store messages and send them to the server in a
packet or only when the messages are requested rather than individually to
conserve bandwidth.
SNF Minimum
Reports
Store and Forward Minimum Reports. Specifies the minimum number of reports that must
be stored before they are forwarded to the server. The data is then sent to the server in
packets that contain at least this number of reports.
n=0-255
SNF Simple Reliable
Max. Retries
Maximum number retries when in Simple Reliable Mode.
n=0 : Disabled
n=1-255 retries
Redundant Server 1
IP and Redundant
Server 2 IP
Send duplicate unreliable report to this Server.
Redundant Server 1
Port and Redundant
Server 2 Port
Send duplicate unreliable report to this port.
Command Description
Vista de pagina 122
1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 236 237

Comentarios a estos manuales

Sin comentarios