
LAN/WiFi Configuration
Rev 2.0 C Aug.10 55
Tip:
You may need to use Private Mode to configure the IP address of your AirLink device
to be available on a LAN.
Note: To configure a PPPoE connection on Microsoft Windows XP, 2000 or NT, you will
need administrator privileges to the computer you are configuring or access granted by an
administrator on the network to add/remove devices to your computer.
Figure 5-22: ACEmanager: LAN/WiFi- PPPoE
Configure your AirLink device to support PPPoE
• From the groups on the left, select PPPoE under LAN.
• Change Host Auntentication Mode to 2.
• Enter a user name for PPP User ID for the PPPoE connection.
• Enter a password (PPP password) for the PPPoE to connection.
Tip:
If you leave
PPPUserID
and
PPPpassword
blank, any computer or device can
connect to the PinPoint device using PPPoE.
Command Description
Host Authentication
Mode
Host Authentication Mode: Use PAP or CHAP to request the user login and password
during PPP or CHAP negotiation on the host connection. The username and password set
in *HOSTUID and *HOSTPW will be used.
• Disable PAP or CHAP request (Default)
• PAP and CHAP
• CHAP
PPP User ID Host User ID for PAP or CHAP.
• user id (up to 64 bytes)
PPP Password Host Password for PAP or CHAP.
Comentarios a estos manuales