Sierra Wireless AirLink MP Guía de usuario Pagina 122
- Pagina / 237
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
ALEOS User Guide
116 20080616
Command Description
Report Server IP IP address where Event Reports are sent (RAP Server IP). Also see *PPPORT.
• d.d.d.d=IP address
Example:
AT*PPIP=192.100.100.100
Server Port Port where GPS reports are sent.
• n=1-65535
Minimum Report Time
(secs)
Report Time Interval.
n=seconds (1 - 65535)
Note: Your cellular carrier may impose a minimum transmit time.
Caution:
A report time of less than 30 seconds can possibly keep an RF link up continu-
ously. This could eventually cause the device to overheat and shutdown. An RF resource
may continue be tied up to transfer small amounts of data. Generally the RF channel will be
released and go dormant in 10-20 seconds of no data sent or received.
SNF Enable Store and Forward will cause GPS reports to be stored up if the device goes out of network
coverage. Once the vehicle is in coverage the reports will be sent en masse to the server.
• n=0 : Disabled
• n=1 : Enabled (default)
Use IMEI for Device ID
in Location Reports
Enabling this will force the use of the IMEI in the Device ID instead of the phone number.
Use Device ID in
Location Reports
Whether or not the device should include the 64-bit device ID in its reports. The Device ID
MUST be enabled if the device uses a Dynamic IP.
n=0 : Disable ID.
n=1 : Enable/display ID.
SNF Reliable Mode Store and Forward Reliability: Reports will be retransmitted if not acknowledged by the
server.
• n=0 : Disabled
• n=1 : Reliable mode enabled for RAP messages
• n=2 : Simple reliable mode
SNF Mode Store and Forward Behavior. When Store and forward is enabled, the type of Store and
Forward behavior is defined by:
• n=0 : Normal Store and Forward. Data is stored when the MP is out of cellular
coverage; when the MP is in coverage, data is sent to server as soon as possible. This
is the default form MP devices with RAP version 1.3 or lower.
• n=1 : Data sent only when polled. Data is stored until polled using the Poll command
sent by a server.
• n=2 : Grouped Reports. Data is stored until the desired minimum number of reports
(see *PPSNFM) has been stored. The data is then sent to the server in groups with at
least the specified number of reports.
- ALEOS Configuration 1
- User Guide 1
- Trademarks AirCard 4
- Contact 4
- Information 4
- Revision 5
- Rev 2.0 C Aug.10 2 8
- Rev 2.0 C Aug.10 3 9
- ALEOS User Guide 10
- 4 20080616 10
- Contents 11
- Rev 2.0 C Aug.10 5 11
- 6 20080616 12
- Rev 2.0 C Aug.10 7 13
- 8 20080616 14
- Rev 2.0 C Aug.10 9 15
- 10 20080616 16
- 1: Introduction 17
- 12 20080616 18
- Tools and Reference Documents 19
- 14 20080616 20
- Main Menu Tabs 21
- Configuring 22
- Operation Modes 22
- Data Communication 23
- Applying Templates 24
- Figure 2-5: ACEmanager : Load 26
- Rev 2.0 C Aug.10 21 27
- 22 20080616 28
- 3: View Status 29
- WAN/Cellular 30
- LAN/WiFi 31
- 26 20080616 32
- VPN connection has been made 32
- Security 33
- Services 33
- 28 20080616 34
- View Status 35
- Rev 2.0 C Aug.10 29 35
- 30 20080616 36
- • Off (Default) 36
- Applications 37
- 32 20080616 38
- 4: WAN/Cellular Configuration 39
- WAN/Cellular Configuration 41
- Rev 2.0 C Aug.10 35 41
- • apn=access point name 41
- ACEmanager 42
- Keepalive 44
- Data usage using Keepalive 44
- 5: LAN/WiFi Configuration 45
- 40 20080616 46
- Host Port Routing 47
- Wi-Fi devices 48
- LAN/WiFi Configuration 49
- Rev 2.0 C Aug.10 43 49
- Shared WEP 50
- WPA/WPA2 Personal 50
- WPA Enterprise 51
- Installing the USB drivers 53
- Virtual Ethernet 55
- Virtual Serial 57
- Global DNS 59
- 6: VPN Configuration 63
- VPN 1 to 5 64
- VPN Configuration 65
- Rev 2.0 C Aug.10 59 65
- 60 20080616 66
- 62 20080616 68
- 7: Security Configuration 69
- 64 20080616 70
- Port Filtering- Inbound 71
- Port Filtering-Outbound 72
- Trusted IPs - Inbound 73
- Trusted IPs - Oubound 74
- MAC Filtering 75
- 70 20080616 76
- 8: Services Configuration 77
- Configuring Engine Hours 79
- Dynamic DNS 80
- Understanding Domain Names 81
- Dynamic Names 82
- Command Parser 83
- 78 20080616 84
- SMS Gateway 85
- Add a Trusted Phone Number 87
- AirLink SMS Protocol 87
- Email (SMTP) 89
- Management (SNMP) 90
- Time (SNTP) 92
- 88 20080616 94
- 9: GPS Configuration 95
- Server 1 98
- Server 2 to Server 4 100
- PPTSV will also be disabled 102
- Local/Streaming 105
- GPS Configuration 107
- Rev 2.0 C Aug.10 101 107
- 102 20080616 108
- 10: Serial Configuration 109
- 104 20080616 110
- Raven Line devices 112
- MODBUS Address List 117
- 112 20080616 118
- 11: Application Configuration 119
- 12: Report Configuration 121
- Redundant Server 123
- Store and Forward 123
- Reliability Modes 124
- 13: I/O Configuration 125
- Configuration 126
- 122 20080616 128
- 14: Admin 129
- Event Trigger 131
- Event Configuration Types 132
- Digital Inputs 133
- Analog Inputs 133
- 128 20080616 134
- Network 135
- 130 20080616 136
- Configuring Reports 137
- Events Protocol 141
- Additional Reports 141
- Rev 2.0 C Aug.10 137 143
- Configuring Data 144
- AVL Group 145
- Digital I/O Group 145
- Analog Input Group 145
- Network Data Group 145
- Network Traffic Group 146
- Device Name Group 146
- 142 20080616 148
- Caution: 149
- 144 20080616 150
- Rev 2.0 C Aug.10 147 153
- Connection 154
- Figure 1-22: DUN Connection 159
- Figure 1-23: DUN Properties 160
- Figure 1-25: Networking 161
- Figure 1-26: PPP Settings 161
- Note: The direct DUN 163
- ACEview are not available 163
- Windows DUN 164
- 160 20080616 166
- B: Configuring Modbus/BSAP 167
- Host for Modbus on UDP 168
- Modbus with UDP 169
- 166 20080616 172
- C: PPP over Ethernet (PPPoE) 173
- Figure 3-10: PPPoE Connection 177
- Figure 3-13: PPP Settings 178
- 174 20080616 180
- Protocol 181
- SNMP MIB Definition Sample 182
- Display Responses 188
- Product ID 189
- 184 20080616 190
- GPS Overview 191
- Remote Access Protocol (RAP) 192
- Before you Configure GPS 193
- Configuring the Datum 194
- Over-The-Air (Remote) Host 194
- Local Host 195
- TCP GPS Report Polling 195
- Report Types 195
- Sending Reports Automatically 196
- RAP Configuration 198
- Device ID 199
- Odometer Data in Reports 199
- NMEA Configuration 200
- Streaming Messages (Local) 201
- Persistent Streaming 202
- TAIP Emulation Configuration 203
- Local Connection 204
- 200 20080616 206
- F: AT Commands 207
- GPRS Info 209
- CDMA Info 210
- CPU Status 210
- ATS53=T192.168.100.23/12345 212
- ATS53=foo.earlink.com 212
- ATS53=192.168.100.23/12345 212
- ATS53=/12345 212
- Negative = No coverage 214
- Dynamic IP 218
- PPP/Ethernet 219
- PassThru 220
- Low Power 224
- Firewall 224
- Serial Port 230
- Rev 2.0 C Aug.10 225 231
- Table 6-22: GPS: Serial Port 231
- Cellular 232
- Rev 2.0 C Aug.10 229 235
- • n=1-2 Input number 235
- • s=OPEN or CLOSED 235
- Table 6-25: I/O 235
- 230 20080616 236
Relacionado con productos y manuales para Redes Sierra Wireless AirLink MP
Redes Sierra Wireless WISMO218 Manual de usuario
(79 paginas)
(79 paginas)
Redes Sierra Wireless PinPoint X Guía de usuario
(62 paginas)
(62 paginas)
Redes Sierra Wireless AirCard 326U Guía de usuario
(12 paginas)
(12 paginas)
Redes Sierra Wireless AceView Manual de usuario
(24 paginas)
(24 paginas)
Redes Sierra Wireless GL6100 Guía de usuario
(96 paginas)
(96 paginas)
Redes Sierra Wireless USB 598 Guía de usuario
(51 paginas)
(51 paginas)
Redes Sierra Wireless Compass 597 Guía de usuario
(48 paginas)
(48 paginas)
Redes Sierra Wireless USB 598 Guía de instalación
(13 paginas)
(13 paginas)
(24 paginas)
Redes Sierra Wireless Raven XT Guía de usuario
(184 paginas)
(184 paginas)
Redes Sierra Wireless AirLink MP890 Guía de usuario
(67 paginas)
(67 paginas)
Redes Sierra Wireless Telstra Elite Guía de usuario
(24 paginas)
(24 paginas)
Redes Sierra Wireless RAVEN 20080605 Guía de usuario
(50 paginas)
(50 paginas)
Redes Sierra Wireless USB 598 Guía de usuario
(48 paginas)
(48 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.059 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales