
ALEOS User Guide
36 20080616
All Keepalive
IP Address
The IP address that the AirLink Device will ping to determine if there is internet
connectivity and make sure this IP address is accessible.
Set the IP address or valid internet domain name for the AirLink device to ping to keep
itself alive (online). *IPPING must to be set to a value other than 0 to enable pinging.
• d.d.d.d=IP address
• name=domain name
*IPPINGADDR sets the IP address you want to use for the connection test.
If *IPPINGADDR is left blank or is set to an invalid IP address (example, an IP which is
unreachable or one which is not a valid IP address), device performance will be
adversely affected.
Keepalive
Ping Time
The amount of time between pings when the device is idle.
Set the period to ping (if no valid packets have been received) a specified address
(*IPPINGADDR) to keep the device alive (online).
• Disable pinging (default)
• 5-255 minutes
15 minutes is the minimum interval which can be set for Keepalive. If you set *IPPING
for a value between 0 and 15, the minimum value of 15 will be set.
*IPPING sets the interval, in minutes, you want Keepalive to test the network
connection. To disable Keepalive, set *IPPING to 0 (default setting).
15 to 60 minutes is the minimum time which can be set for Keepalive. If you set
*IPPING for a value less than the minimum, the minimum value will be set.
Force
Keepalive
ping
If the ping should occur even if the device is not idle.
Advanced
All Network
Watch Dog
Network connection watchdog: The number of minutes to wait for a network connection.
If no connection is established within the set number of minutes, the device resets.
• n=0 : Disabled.
• n=minutes : Default = 120 min.
EV-DO/1X Network
Authentica
-tion Mode
Specifies the authentication method to be used in the network PPP session.
• PAP and CHAP are two options.
EV-DO/1x Network
User ID
Network User ID
The login that is used to login to the cellular network, when required.
• uid=user id (up to 64 bytes)
EV-DO/1x Network
Password
Network Password.
The password that is used to login to the cellular network, when required.
pw=password (30 characters maximum).
HSPA/
GPRS
Define PDP
context
Easy entry of the APN. If left blank, the device will attempt to use the default subscriber
value as defined by the account.
• apn=access point name
1 and “IP”, are required and not variable. Quotes need to be placed around the APN.
Tip:
When *NETAPN has been configured, +CGDONT will be pre-populated in
ACEmanager .
Carrier
type
Command Description
Comentarios a estos manuales